Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Heater- defrost- question

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Nicke  
Guest





PostPosted: Thu Jul 04, 2002 2:43 am    Post subject: Reply with quote

The heater isn´t blowing any air towards the windscreen. Blows air in any other direction. Better than ever, actually.
I already turned the lever in the passenger side footwell, the one where the wire goes, but it didn´t help. Any ideas before I take the interior apart and break open the heater?

Back to top
Smoothie  
Guest





PostPosted: Thu Jul 04, 2002 2:56 am    Post subject: Reply with quote

My US version of the Haynes has diagram of the vacuum operated components of the ventilation system. It's at the end of chapter 2 on page 70. There's a vacuum unit shown for controlling the defroster flap - maybe yours has gone bad or the line to it developed a leak? Do you have air conditioning? (The other end of the defroster flap's vacuum line goes to the AC switch in this diagram.)
Back to top
Nicke  
Guest





PostPosted: Thu Jul 04, 2002 3:14 am    Post subject: Reply with quote

No air conditioning. Can I get to the flap without too much trouble? I think I could get pretty close by taking out the glove compartment...
Back to top
Smoothie  
Guest





PostPosted: Thu Jul 04, 2002 5:08 am    Post subject: Reply with quote

Someone else will have to help with this. I looked in the parts catalog, but they don't have anything specifically labelled as the defroster flap. If the defroster flap is the one that I think it is, the cable to it comes from the top-left of the controls and goes around the left side of the heater/vent unit and toward the back. Hopefully someone else has had some experience with it and can tell you more.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group