Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

AC Condensor Question

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Rasta Monsta  



Joined: 12 Jul 2006
Posts: 11733
Location: PacNW

PostPosted: Fri Jan 07, 2011 4:01 am    Post subject: AC Condensor Question Reply with quote

I have a PITA favor for anyone who has an AC condensor laying around. I need a measurement for the offset between upper and lower mounts (the top mounts attach forward of the rad subframe, and the bottom mounts rearward, against the lower rad mounts).

I know this will be difficult to measure, but it just needs to be approximate.

Thanks!


Rasta
_________________
Toofah King Bad
  • WeiBe (1987 924S 2.5t) - 931 S3
Back to top
View user's profile Send private message Visit poster's website
Grenadiers  



Joined: 20 Feb 2007
Posts: 3222
Location: Nelson, WI & Prescott, AZ

PostPosted: Fri Jan 07, 2011 5:17 am    Post subject: Reply with quote

If I understand this correctly, you want the measurement from the centerline of the upper and lower mounting grommets? That's 14 inches. I have a condensor out on our back deck if this is incorrect.
_________________
'83 944 Track car.
'88 924S Track car.
'89 944 Turbo
2004 Winnebago Vectra monster RV
2012 Jeep Wrangler
2014 Kia Soul
2001 Ford F350 powerstroke
Back to top
View user's profile Send private message
Rasta Monsta  



Joined: 12 Jul 2006
Posts: 11733
Location: PacNW

PostPosted: Fri Jan 07, 2011 6:34 am    Post subject: Reply with quote

I have that measurement. . .looking for the distance between the plane of the rear side of the upper mounts, and the plane of the front side of the lower mounts.

My thinking is that these are two parallel planes, slightly offset since they bolt up to opposite sides of the rad subframe.

Confusing enough?
_________________
Toofah King Bad
  • WeiBe (1987 924S 2.5t) - 931 S3
Back to top
View user's profile Send private message Visit poster's website
Grenadiers  



Joined: 20 Feb 2007
Posts: 3222
Location: Nelson, WI & Prescott, AZ

PostPosted: Fri Jan 07, 2011 8:49 am    Post subject: Reply with quote

Hmm, might be easier if you spend 20 bucks on shipping, and I'll send you the damn thing~! I have no clue, the 'ear' mounts on all four corners look the same to me. Plane or no plane!!
_________________
'83 944 Track car.
'88 924S Track car.
'89 944 Turbo
2004 Winnebago Vectra monster RV
2012 Jeep Wrangler
2014 Kia Soul
2001 Ford F350 powerstroke
Back to top
View user's profile Send private message
Rasta Monsta  



Joined: 12 Jul 2006
Posts: 11733
Location: PacNW

PostPosted: Fri Jan 07, 2011 9:26 am    Post subject: Reply with quote

So if you lay it down, the mounting ears are the same distance from the ground?

There I go, overthinking schitt again.
_________________
Toofah King Bad
  • WeiBe (1987 924S 2.5t) - 931 S3
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group