924Board.org

[Joes924]

I had nothen better to do today than work on my car all day, removed the wheels & the rear konis.Cleaned up the cv boots and joints
& cleaned more stuff[trailing arms etc.On
the front I noticed there is a lot of slack in the drivers side brake rotor figured the clamping nut needed adjusting[removed the brake caliper]cant get the bearing cover off
is the speedo sealing compound maybe holding it on I squirted it up real good with wd40 for the night any suggestions.The brakes were just done last year new master cylinder and rear brake cylinders.


[ This Message was edited by: Joes924 on 2002-03-03 14:06 ]

[Zuffen]

First of all did you remove the circlip on the cable end coming out of the cap?

If you did just pry the cap off.


_________________
Bob Dodd
14 Porsches and counting.
6 931 two of each year, including a 80S
3 924 77,77,80 all for parts
4 944 82,84,85,86 all for parts
1 sad 912 for parts

[ This Message was edited by: Zuffen on 2002-03-04 03:34 ]

[jamez]

they get stuck on there really good, I had to use a hammer, and pound outward on the lip.. but make sure you remove the circlip holding the speedo cable...

[Joes924]

Well I got the bearing cover off just with channel locks I see the groove for the cir clip[it was missing].. The outside bearing
is shot[I ran to the parts place and was able to get another[bearing]. Its all back together again ..Thanks alot