924Board.org

eturbo924 · Guest

http://www.titanic.co.uk/944/paulsmith/enhancements_files/9sills.jpeg

Take a look at the link above. Anyone know a supplier is the US for these?

Eric

numbers · Guest

Nope, but they do look good.

wdb · Guest

If you dont find them, jewelry stores have ingravers that can copy those graphics. A piece of stainless or polished aluminum ,and a few modifications , doesnt look to hard .

Vince Ponz · Guest

This past weekend I helped out a friend at Tech Tactics in Springfield, Mass and he was selling polished Alum. ones but that said MOMO on them. Looked nice.
Interested? Let me know and I can get them for you.
Or go to VAS Enterprises on the web. He will not have them on the web but you can ask him directly. Mention my name.
Vince

eturbo924 · Guest

Vince Thanks for the post, but I want the Porsche ones if I can find them. I have found the company that made those particular ones. They are in GB, but now trying to find a local distributor. I think I have found one in NY but can not get their site to work properly.

Thanks again

Eric

jamez · Guest

Vince is there anyway you could post some pics?

eturbo924 · Guest

Hey guys I have a distributor interested in getting into this market. I need 5 people that want these to commit and I can get those first 5 samples (kit) for $30. These would be same as the ones in the picture except no markings. You need special permission from Porsche to market the name.

So what I need is to get those MOMO ones and see if these are the ones that people want. If yes than the first 5 that commit can have the $30 cost. From there I am not sure where the price will go, but typical cost is about $50-60.

Let me know guys and I will check out the MOMO ones.

Thanks

Eric
Eric.lynch@itt.co

Guest · Posted: Fri Mar 08, 2002 7:03 am Post subject:

Do they replace the entire stock door threshold or do they bolt inside the door jamb?

jamez · Guest

so are the first 5 ones gonna be unmarked or are they gonna be the momo ones?

jamez · Guest

if they are unmarked count me in,I'm sure someone could engrave "Porsche" on them for me...

Vince Ponz · Guest

I was not interested in them when I first saw them. Makes sense now. Remember I only handled the MOMO type. Polished alum with the words MOMO on them.
NOWWWWWWWWWWWWWWWWW who says that we can't buy these and reverse them and have them engraved with the Porsche script. Of course this is illegal and should not be done under any instance.
Want the MOMO type let me know. Cost $60 plus freight.
Or call 516 775 1060 speak to Vic mention my name.

eturbo924 · Guest

They will be un marked. That way you can go and have them marked any way you want.

The ones that I am working on should just be a press on design. Similar to the way the 944 or Turbo badges go on the rear of the newer cars. It covers the section as seen in the picture attached in the original post.

So Jamez wants a set. Anyone else?

Eric
Eric.Lynch@itt.com

jamez · Guest

I was thinking maybe it would look good if I just masked off "Porsche" and then etched it with acid.... anyone have any thoughts on that?

wdb · Guest

mask off with heavy duct tape and sand blast them , clean with solvent and spray with clearcoat would be ,cheaper , easier , safer.