Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

cast in the oil.
Goto page Previous  1, 2
 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
Rick MacLaren  
Guest
PostPosted: Sat Jun 29, 2002 2:44 pm    Post subject: Reply with quote
That's right. There's no bearing.

Mind you, roller bearings would be awesome on the 924. Can't get 'em though.

Back to top
larso  
Guest
PostPosted: Tue Jul 02, 2002 5:01 pm    Post subject: Reply with quote
When the bearing is worn down a lot, to the bottom there is copper. The middle of the bearing is magnetic. I'm not sure about new bearings.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group