Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Oil Pan Removal with Engine in Place?
Goto page Previous  1, 2
 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
K-Roll931  



Joined: 08 Jul 2017
Posts: 76
Location: Southfield, MI
PostPosted: Mon Mar 04, 2019 4:07 pm    Post subject: Reply with quote
I didn't have too much trouble doing this job with the engine in the car. Just did the pan gaskets last month. One of both the 5mm and 6mm allen head bolts were slightly rounded which made extraction difficult. The crossmember removal and disconnecting the steering gear was painless, and the motor mounts went untouched.

I had more difficulty lining up and reinstalling the pan alone. It's easier with two pairs of hands
_________________
'80 931 M471 - Dolomite Gray -> Monaco Blue
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group