924Board.org

Anybody know what the specifications are for resistance values in a working fuel level sender? My fuel gauge is lying and both senders I have read different on the multimeter. I'm trying to decide if ...

Interested in this as well, now that I have the EFI system working well it's time for boost.

This is the one that I printed. It has slanted slats in the vent.

https://www.thingiverse.com/thing:271757

What do you mean by "flat"?

I 3D printed one that I found on the internet. Looks good but I have no idea if its the right size since I don't have a turbo panel to try it in. I'll post a picture when I get home.

I put some "Dynamat" knock off material on the inside of the door skin which helped alot as well.

Make sure that you can get the plug in the fill hole out before you drain the oil. No point in draining the oil if you can't fill it back up.

Haven;'t had a look at your tuning files yet but one thing I noticed is that you say you have a 36-2 toothed wheel for the Ford EDIS. I am using a 36-1 wheel which I believe is the correct configurati ...

Actually that might be a good idea. A PITA though since I just replaced the wiring that went to the starter and the alternator. I had to remove the alternator to replace bushings and the starter to re ...

So after a multi day battle with my starter I have now replaced it. I used the starter from my parts car (1981 2.0l NA). The replacement starter was bench tested fine. The car started multiple times w ...

I have removed and reinstalled my stater and alternator to replace the wiring to both. Now that I have replaced them I seem to have run the wires incorrectly. Right now the large gauge wire from the ...

I am having a hard time removing the top bolt on the starter. I have the bottom bolt out and I can just barely get a box end wrench on the top bolt's head but I have no leverage. I can't get an extens ...

Anybody know what size and shape the bolts holding the CV joints are? I have a set of the "triple square" drivers and the M8 seems to fit well but now I'm unsure if this is the correct size. ...

I like the look of those last ones you posted but I have never seen a stud mount for a hood support in a 924. Not sure how they can be OEM quality when there is no OEM part.

Thanks for the help. It makes sense now and things are working as they should. Raising the rear haych now turns on the light in the back and the cabin light in the passenher compartment. That was unex ...

Yes I understand that part, there are two wires. One supplies 12V and the other must go to ground somewhere. Neither of the two wires is connected to ground.
Where is the ground point for current t ...