924Board.org

Very very few swaps actually worked and even fewer were kept and driven.
Most end up at the scrap yard as technical challenges kill time, money and excitement.
Think about it this way, if a carb con ...

Spent the weekend up on the mountains at our annual Porsche meeting, 10 years since the first meeting now.
Sadly my 924 wasnt ready in time for the meet so i took the 996.
Had a blast driving the 99 ...

Steve, thank you for the value you have put into the community and the 924 scene.

Your old 931 was one of the most iconic 924s out there, well known and recognized all over the world.
The car will ...

Most likely seals are shot and thats all you need to do, but you have to inspect it when changing the seals.

Good luck with those seals, i could not find the right ones, they sent me the wrong ones ...

The fluid is in the brake booster. You will see it once you remove the pump and you will need to extract it.

Seems like there is some flaw with that relay after all, you were correct.

I find it strange that the relay would prime the pump when the engine is cold but not when the engine is warm, so at this point my money is on the following scenario:

It may be important as our rel ...

Phone tray to fix the carpet problem?

Chuck, I think that ebay relay works, you just had a hot start problem. Did you try the relay again after that?

At this point my EFI kit does not control the fuel pump relay, but i think in the fut ...

Cool factor 10/10.

I'm starting a new build run of EFI kits 15th of September.

There are some guys already on the list but i figured i'll announce here as well to be able to properly size the the list and build.

S ...

Try importing one, or try hitting the local scrapyards.
Other USA guys have done one of the two and found the TBs.

If you cant find one, i'll find one for you and put in in the kit box.
Did that ...

I also have one, great book indeed.

Sounds like a nice collector 924, lets see some pictures.

maybe the shaft isnt bent but the bearings sleeves are deformed/crunched and the shaft sits at an angle ?