| View previous topic :: View next topic |
| Author |
Message |
agfisher
Joined: 09 May 2007
Posts: 451
Location: West Hartford, CT
|
 Posted: Thu Jan 21, 2021 1:38 pm Post subject: 3D Printed Spatkpkug Wire Loom |
 |
|
I built up a replacement part for the two sparkplug wire looms that mount to the valve cover. Mine got so brittle they feel apart when I pulled the wires out. So if you have a 3D printer ir access to one give it a shot.
https://www.thingiverse.com/thing:4731076
Enjoy!
_________________
1977 924 N/A Martini Edition |
|
| Back to top |
|
 |
Mike9311
Joined: 14 Dec 2004
Posts: 991
Location: Chicago-ish
|
| Posted: Sat Jan 23, 2021 12:33 am Post subject: |
|
|
Cool, thanks
What material did you use?
_________________
1980 931 since 1989
1981 Ideola 931 Club Sport
1982 931 Entwicklungsfahrzeug
1979 924 NA M650 Herausnehmbares Dach
1982 931 Red Resurrection - 951 IC
1982 931 parts car / resurrection?
1980 924 NA (R&D lightweight)
1982 931 wana-be GTR race car |
|
| Back to top |
|
|
agfisher
Joined: 09 May 2007
Posts: 451
Location: West Hartford, CT
|
| Posted: Sat Jan 23, 2021 1:53 am Post subject: |
|
|
The prototype in in PETG. My car isn't running right now so I can't get a reading on what the temperature may be in those locations. Once I get it running, I can figure out what material will be best and has a high enough glass temperature to survive.
Adam
_________________
1977 924 N/A Martini Edition |
|
| Back to top |
|
|
Mike9311
Joined: 14 Dec 2004
Posts: 991
Location: Chicago-ish
|
| Posted: Sat Jan 23, 2021 5:03 am Post subject: |
|
|
Always curious, thanks
Would have been my first choice too
_________________
1980 931 since 1989
1981 Ideola 931 Club Sport
1982 931 Entwicklungsfahrzeug
1979 924 NA M650 Herausnehmbares Dach
1982 931 Red Resurrection - 951 IC
1982 931 parts car / resurrection?
1980 924 NA (R&D lightweight)
1982 931 wana-be GTR race car |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
924 FAQ (Technical)
