Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Heater & AC control and cables

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
ted von Kampen  



Joined: 14 Oct 2016
Posts: 183
Location: Scottsbluff, Nebraska

PostPosted: Tue May 14, 2019 10:06 am    Post subject: Heater & AC control and cables Reply with quote

I have a 1981 Porsche 924 NA that I have been restoring. I recently found the heater control panel and attached Bowden cable are not working correctly. While I found that the lower plastic edge has broken in one corner, I have a question that maybe someone can answer. On the middle lever there appears to be 2 Bowden cable attached. One goes to the hot water cooling valve in the engine compartment. Where does the other one go? Also on the middle lever there appears to be 3 holes where the cable attaches. To which holes do the 2 Bowden cables attach? and which cable goes to which hole?
The upper lever goes to a flapper door as does the lower lever. I hope someone can answer these questions. Thanks in Advance.
Ted von Kampen
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group