Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

how to disconnect door wiring connectors

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
ted von Kampen  



Joined: 14 Oct 2016
Posts: 183
Location: Scottsbluff, Nebraska

PostPosted: Sat Apr 15, 2017 9:04 am    Post subject: how to disconnect door wiring connectors Reply with quote

The drivers door on my 924 has 3 wire harnesses that come out the bottom of the door and go into the pillar. In the pillar cavity there are 3 connectors that link these wires to the main harness, etc. The 3 sets control the electric mirror and power windows. I want to replace the rubber boot in the door. One of the connectors is round and presented no problem getting apart. The other two are flat. One with several wires and one with 2 wires. I can see no part line to get the connectors apart. The plug is marked VW and is the original harness. I can see through to the connector pins but cannot see how to separate. Any suggestions?
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group