|
924Board.org Discussion Forum of 924.org
|
View previous topic :: View next topic |
Author |
Message |
K-Roll931
Joined: 08 Jul 2017 Posts: 76 Location: Southfield, MI
|
Posted: Thu Jun 04, 2020 11:43 am Post subject: G31 Angular Joint Installation Woes |
|
|
Somehow, I decided that installing this could wait, even after I had everything within reach while doing the RMS, clutch, and even the bushings at the rear over the winter and early spring...Anyways, I'm now in the process of installing this PITA with the gearbox disconnected from the rear suspension and axles, and see only two ways to get it installed now without knackered up hands and fingers.
1. Remove the four bolts holding the torque tube to the bellhousing and slide the tube back a foot or so to have the same reach I had over the winter. The only problem is it required two people to push the torque tube back in place and I suspect that'll happen again.
2. Remove the gearbox entirely...I'm partway there, but I've never done it before and I'm seeing it as a bit overkill, and seems riskier than the former option...I could be wrong.
Advice? Tips and Tricks? _________________ '80 931 M471 - Dolomite Gray -> Monaco Blue |
|
Back to top |
|
|
Carrera RSR
Joined: 08 Jan 2010 Posts: 2309 Location: Somerset, UK
|
Posted: Thu Jun 04, 2020 6:41 pm Post subject: |
|
|
Leave the gearbox on the torque tube. Drop the box off its mountings and allow it come down on a jack/support as far as it goes. It will be tight but potentially doable unless the old joint is really corroded onto the shaft. Count the turns off. Count the turns back on.
If the gearbox is easy to pull, then pull it. It will make life easier to reach into the TT area to swap the joint. _________________ 1980 931 - forged pistons, Piper cam, K27/26 3257 6.10 hybrid turbo, 951 FMIC, custom intake, Mittelmotor dizzy & cam pulley, H&S exhaust, GAZ Gold, Fuch'ed, Quaife
Now www.924board.org/viewtopic.php?t=34690
Then www.924board.org/viewtopic.php?t=31252 |
|
Back to top |
|
|
K-Roll931
Joined: 08 Jul 2017 Posts: 76 Location: Southfield, MI
|
Posted: Fri Jun 05, 2020 6:05 am Post subject: |
|
|
Carrera RSR wrote: | Leave the gearbox on the torque tube. Drop the box off its mountings and allow it come down on a jack/support as far as it goes. It will be tight but potentially doable unless the old joint is really corroded onto the shaft. Count the turns off. Count the turns back on.
If the gearbox is easy to pull, then pull it. It will make life easier to reach into the TT area to swap the joint. |
I'm halfway to dropping the snailshell. Should have it out either tonight or tomorrow afternoon.
I'm following this very helpful guide someone here had made: https://www.freewebs.com/patand/vxelldsbyte.htm _________________ '80 931 M471 - Dolomite Gray -> Monaco Blue |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|