Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

DIFF BACKLASH PROBLEM

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
AFRICA DEE  



Joined: 16 May 2006
Posts: 48
Location: JOHANNESBURG, SOUTH AFRICA
PostPosted: Mon Jun 19, 2006 10:24 pm    Post subject: DIFF BACKLASH PROBLEM Reply with quote
I need some advice. I thought I had a problem with a noisy left rear CV, but it was strange because it only made a noise after a corner and the car was pointing straight again.

My car has the 5-speed dog-leg shift tranny, no lsd.

So the shaft and CV's came out and look fine, but the left rear short shaft that goes into the diff has about 3-5 mm forward play on the left but not on the right.

Is this the/a problem and what is the fix??

I have read a comment by Raceboy that there is a weak spline set up that holds a sattelite gear shaft in place but does not know if this is similar?

Thanks
_________________
1980 924 N/A Ex-931 Track car: My cash guzzler
2004 996 4S: My Weekend plaything
2012 VW POLO GT: My daily commuter
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group