Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Sorry have to post this again: where to get 0.5mm...

 
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Discussion
View previous topic :: View next topic  
Author Message
QuadESL63  



Joined: 07 Jun 2003
Posts: 33
Location: Calgary

PostPosted: Tue Feb 10, 2004 6:27 am    Post subject: Sorry have to post this again: where to get 0.5mm... Reply with quote

undersized main bearings?

BTW, can I use the one from other Porsches?

Thanks!

I have tried a lot of places, including the nice folks at PAECO (Carl told me he tried a few suppliers and the bearings are in their "back order" a.k.a. no one has them).
Back to top
View user's profile Send private message
Paul  



Joined: 02 Nov 2002
Posts: 9305
Location: Southeast Wisconsin

PostPosted: Tue Feb 10, 2004 1:44 pm    Post subject: Reply with quote

Have you tried EBS?
Back to top
View user's profile Send private message Send e-mail
QuadESL63  



Joined: 07 Jun 2003
Posts: 33
Location: Calgary

PostPosted: Tue Feb 10, 2004 2:15 pm    Post subject: EBS? EBS Racing? Reply with quote

Paul wrote:
Have you tried EBS?


Hi Paul,

EBS Racing? http://www.ebsracing.com/water.html Not really... Thanks for the suggestion though. I will try.

Any other suggestion? Thanks!
Back to top
View user's profile Send private message
wdb  



Joined: 02 Nov 2002
Posts: 2024

PostPosted: Tue Feb 10, 2004 3:23 pm    Post subject: Reply with quote

I have not verified this , but the vw 2.0l main bearings might fit ,they cost about $30 . maybe you could find the specs and compare or gamble and buy a set and see . the rod bearings from the vw 1.9l turbo diesel are the same diameter ,but I dont know if thet are a swap for sure ,cost around $20 . the bearings from a 77-79 amc concorde are a direct swap ,I forget the cost .

also several members have had failures after a rebuild, a few vw/audi guys say to replace the rod bolts when doing the bottom end ,because they are notorious for failing .
Back to top
View user's profile Send private message
Paul  



Joined: 02 Nov 2002
Posts: 9305
Location: Southeast Wisconsin

PostPosted: Wed Feb 11, 2004 11:33 am    Post subject: Reply with quote



Call toll free: (800) 462 3774
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Discussion All times are GMT + 11 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group