Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

HEAD

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
void1  
Guest





PostPosted: Tue Aug 14, 2001 8:29 am    Post subject: Reply with quote

I AM TRYING TO REMOVE THE 4 INJECTER SEATS, I REMOVED TWO BUT THE OTHER TWO STIPPED, SINCE THEY ARE PLASTIC. ANY IDEAS ON HOW TO REMOVE THEM. OR SHOULD I LET THE MACHINE SHOP DEAL WITH IT?

[ This Message was edited by: void1 on 2001-08-14 08:30 ]
Back to top
Dave  
Guest





PostPosted: Tue Aug 14, 2001 1:28 pm    Post subject: Reply with quote

Let The machine shop do it. If they brake them they have to replace them
Back to top
AppleBit  



Joined: 16 Nov 2002
Posts: 1516
Location: Minneapolis, MN

PostPosted: Wed Aug 15, 2001 1:02 am    Post subject: Reply with quote

always spray a little silicon spray to lube them up... this always helps to pull them in and out...


_________________
Classic British Sports Car Restoration v6 + v8 Engine Conversion Swaps

Porsche 924 Wide Body LS1 Corvette 500 Horsepower Engine
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group