Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Starter and altenator wiring issue.

 
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions
View previous topic :: View next topic  
Author Message
procyon  



Joined: 09 Sep 2015
Posts: 63
Location: Peers Alberta Canada

PostPosted: Wed Mar 24, 2021 12:05 am    Post subject: Starter and altenator wiring issue. Reply with quote

I have removed and reinstalled my stater and alternator to replace the wiring to both. Now that I have replaced them I seem to have run the wires incorrectly. Right now the large gauge wire from the + terminal of the battery and the bundle of 3 wires both go on the underside of the starter and then up between the stater and the alternator. This seems to interfere with the oil filter and I don't remember them being there when I did oil changes. Also the wire is not long enough to reach back to the clips on the firewall. How should the two wires run?
_________________
1981 924 N/A (Now the parts car)
1980 924 N/A ( 5 bolt discs and better paint) MS II V3.57
2003 Subaru Baja
2021 Maxda CX-30
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> General Discussions All times are GMT + 11 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group