Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Motor mount replacement
Goto page Previous  1, 2
 
Post new topic   Reply to topic    924Board.org Forum Index -> How-To
View previous topic :: View next topic  
Author Message
DentalFlossTycoon  



Joined: 27 Nov 2016
Posts: 38
Location: Bozeman, MT
PostPosted: Mon Feb 01, 2021 7:21 am    Post subject: Job done Reply with quote
After much complaining, some of it public here, I finished the job. It is only a hassle because of the challenging angles and tight spaces surrounding the arms that mount to the block. On the intake side, I ended up pulling all the mounting arm bolts but not the whole mounting arm: by jacking up the engine (more than made me comfortable) I could jiggle out the old mount and get the new one in. Getting it done means being aggressive about partially undressing the engine and then using every extension, swivel, and wrench in the garage to get to most of the nuts and bolts.

It was definitely worth it though.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> How-To All times are GMT + 10 Hours
Goto page Previous  1, 2
Page 2 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group