Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

Rod and piston orientation

 
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech.
View previous topic :: View next topic  
Author Message
a239947  



Joined: 15 Nov 2015
Posts: 23
Location: Australia

PostPosted: Wed Mar 08, 2017 11:18 pm    Post subject: Rod and piston orientation Reply with quote

Hey guys. Im doing a rebuild on my 931 following a blown head gasket and what i believe are worn rings.
When i dropped the block, pistons and rods off at the machinists today he asked which way the rods and pistons go.
In my haste to strip the block down i did not take note of these things.
Is there anybody here that can tell me which way these go so i can pass it on.

Cheers
Back to top
View user's profile Send private message
MikeJinCO  



Joined: 08 Jun 2010
Posts: 670
Location: Maysville, Colorado

PostPosted: Thu Mar 09, 2017 12:22 am    Post subject: Reply with quote

I believe the oil squirter hole on the rod goes toward the back. There are also some protrusions(Haynes calls it a pip) on the rods near the bolt and the should be oriented toward the front. There should also be directional arrows on top of the pistons.
_________________
Mike
Poco a Poco, '80 future track car
'77 924
cricketdesigns.com
Back to top
View user's profile Send private message Visit poster's website
a239947  



Joined: 15 Nov 2015
Posts: 23
Location: Australia

PostPosted: Sun Mar 12, 2017 2:17 am    Post subject: Reply with quote

Thanks for the reply. I know the haynes manual refers to the NA model but im guessing the turbo should be similar.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 931 Tech. All times are GMT + 11 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group