Show full size 924Board.org
Discussion Forum of 924.org
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 Technical FAQ924 FAQ (Technical)   Technical924 Technical Section   Jump to 924.org924.org   Jump to PCA 924 Registry924 Registry

catalytic converter?

 
Post new topic   Reply to topic    924Board.org Forum Index -> 924S Discussions
View previous topic :: View next topic  
Author Message
GRATIAN  
Guest





PostPosted: Sat Aug 24, 2002 10:34 pm    Post subject: Reply with quote

I think my converter is guncked up and the car is very slow in acceleration, so I vant to remove the catalytic converter but keep the oxigen sensor.This action will change the car in performance and fuel consumption?
No problem about emmisions in this country.
Back to top
Revis Rose  
Guest





PostPosted: Mon Aug 26, 2002 10:30 am    Post subject: Reply with quote

Yes there is a solution. Disconnect the Oxy sensor and remove the head pipe/Catalytic converter from the car. Put on a dust mask and take a long metal rod and proceed to knock the stuffing out of your cat. You will want a dust mast because I know this is a dusty job, as I had to do it on my '81 924 so I could drive to work a few years ago. It might be a bit easier to cut the cat off all together and to install a piece of pipe instead though.
Good luck,
Revis
Back to top
Display posts from previous:   
Post new topic   Reply to topic    924Board.org Forum Index -> 924S Discussions All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group