924Board.org

New keys are not made from the same quality steel they used to be. We had a stock of old keys and they were a lot harder than the new ones off the boards. However if the key is not turning at all then ...

Ok cool. You would have thought the haynes would have that little nugget of info. Thanks for that I will get that sorted tomorrow.

Hi everyone I have been having trouble getting the car started and I have now replaced pretty much the whole fuel system as I found many problems with it. I have just found that the dot on the cam pul ...

Interesting. I was just looking around at cheap donor cars and came across a 2.2 prelude on a 2000 plate. just daydreaming at the moment but might be interesting.

Has anyone put a 2.2 vtec into a 924? Just wondering if its been done or if there's any reason why not.

Thanks for the replies guys. I didn't check the amount of flow due to not having a measuring jug bar the one in the kitchen and the wife would chop off my manhood if I used that. I did wedge the plate ...

I'm going to change the fuel filter anyway so no worries there. I didn't really want to take the fuel dizzy off but the one that's now on the car is a replacement but I think I may have to clean it ou ...

Hi folks. Been messing with the car again today trying to figure out why it wont start. I have traced it down to a fuel problem. After much messing with various things including fitting a new air fuel ...

Thanks mate as I suspected the one on mine isn't correct. Another bodge from its manual conversion rears its head

Anyone have a pic of the clutch cable mount as the one in my car doesnt look right.

Thanks

Found it today its not on the gearbox it runs off the ignition stop switch on the gear selector. Found the wires taped up under the centre console so I will sort that this week.

Found it today its not on the gearbox it runs off the ignition stop switch on the gear selector. Found the wires taped up under the centre console so I will sort that this week.

No ideas on the reverse light?

Hi folks got myself a new project car that's been laid up for ten years. So far I have only had time to give it a quick once over and check out a couple of things. I will start a proper thread once I ...

I would do plan b myself it would be the easiest solution and seen as half the jettas missing anyway should save some fabrication. Wont be easy but should be cool.