924Board.org

Time let the project go everything wokrs but the A/C and power mirrors.. $3800 obo. Full mechanical refurbish and paint.
https://sites.google.com/a/grsharedtime.com/www/-87-porsche-924s

finallly sourced the "correct" early starter, the bigger bodied one and have not had a kick back issue since, note thet retailers won't differentiate starters and will supply the later, smal ...

Trying to fire up the '87 924s for the spring, blew the nose off the starter, again, this is #3 destroyed. I'm going to try to verify the bell housing isn't from a turbo 944 (they say the starter mou ...

Yes, it was fun to uncrimp that thing. I could not get any tool under the "seam" for love or money. I finally took a cut off wheel via my dremel and sliced the back side to provide a place ...

Old thread I know but a "classic" issue.
I too had the whole odometer gear and shaft shift away from the worm gear, I too just pushed it back and it works fine (on the bench with an old cab ...

I haven't tested the final version yet but it might work, beats $160.
https://www.thingiverse.com/thing:2879330

i also solder and shrink wrap everything, as I did this O2 sensor, and it's replacement and it's replacement but it really is a thing, not supposed to solder, just crimp

trying to get the sunroof operation, finally, two years we've been at this car, almost there.........
We didn't take the interior out and whoever did was drunk and using a sledge hammer EVERY thing i ...

That's what I thought but WRONG, you NOT supposed to solder them, just crimp. It needs air flow within the wire strands. It's a thing.

PS
car has been running fine

took an 8 mile run yesterday, about 2 miles in we pulled over and plugged in the O2 sensor, idle changed a bit, took off, car runs much better with sensor in operation, drove another 4, stopped (to bu ...

two sensors, same issue, yes we can run without it at all, it's okay, we can plug it back in after everything is hot and no issues, I have 12+ volts on the sensor's heater wires with key on, one is th ...

power loss, was back on next start up, can idle for 90 seconds, stumble ensures, unplug O2 sensor, clears out, plug back in, goes bad
ran with disconnected sensor for a few days,
confirmed power on ...

Put old O2 sensor back (I'm a pack rat). Car did not exhibit symptoms. Looks like it was o2 sensor all along, well, pending further testing. I timed it, stumble occurred almost exactly at 90 second ...

New sensor in. Same deal, in fact it was worse than ever, got about 300 ft from the shop, headed right back, thought I'd disconnect the O2 sensor while it was acting up, opened the hood, it was runni ...