924Board.org

A little while ago I have away my spare fuel relay to resurrect someone's 924 and have been searching for a new spare since then. Today I tried a 92861511301 and it worked fine ... plug in, no mods r ...

So after many hours of looking at pin specifications, today I successfully replaced my faulty fuse box pin. This is the male pin that slides into the female connector located in the plug that plugs i ...

Appreciate the heads up Mclaren. I've ordered some parts to repair my exisiting fuse box. If it works I'll post the details on the board. If it fails, I might take you up on your offer.

Reading old fusebox messages as I try to work out how to repair/ replace my fusebox.

When i compare the 171941813 vs 477941813 fusebox, the rear pin outs look substantially different between the ...

Hi Bill,

I suspect we are both working on similar faults at the moment. The specific pin is the number at the point you've highlighted (your pics's resolution isn't good enough to see number and ...

I currently have my fuse box out trying to repair. Here are pics of the back of my fusebox, if you need more of a close up, let me know and I'll take specific pictures.

https://1drv.ms/i/s!AuI ...

Recently I decided to find out why my LHS low beam headlight wasn't working. After fault finding, I determined that my issue was the connection between the load size of the fuse and the male pin in t ...

I typically run with my cover off. It doesn't look as nice however it allows for frequent timing belt inspections and creates a little bit more room for other work in the engine bay.

From time to ...

So recently my radiator cooling fan motor started making a terrible noise. Removed it and it's obviously in need for a replacement. Even though my 931 had air conditioning installed (in Australia, I ...

Yes, I did install the thermal paste. I was actually organised and purchased the paste in preparation for when the unit arrived.

To my surprise, the unit arrived with a little tube of paste so my ...

Hi all,

So for the last few years I've had an issue where my car would run really well ... then just stop. Initially it would restart after this occurred however over time it was taking longer and ...

Have you replaced the starter/alternator/battery harness? I'm going through that now.

A company called Kroon makes them for 79/80 924 turbos.
https://www.kroonwireharnesses.com/porsche-924/porsch ...

Hi Bear,

According to my wiring diagram, terminal 3 if the DITC plug (green-white wire) connects to terminal 6 on the transistor ignition box on the front fender, and from terminal 1 on the same bo ...

My 924 fault finding has been delayed with a house move between my last post and now.

Finally had a chance to measure the volltage between pins 1 and 31 when the car is running correctly. So with ...

So my excitement about finding a loose wire has proven to be ill placed! Took my 924 out last weekend and after operating perfectly for an hour my car cut out while driving down the road. The good p ...