 |
924Board.org Discussion Forum of 924.org
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
924 FAQ (Technical)| Search found 7 matches |
| Author | Message |
|---|---|
 Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
 Forum: 931 Discussion Posted: Thu Oct 21, 2004 4:18 pm Subject: 1980 931 ingition troubles |
| So today I put in my coil and redid some wires that were corroded and broken. I found that the plug that goes to the distributor had conductivity no matter which way i put the leads from the ohm meter ... | |
| Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
Forum: 931 Discussion Posted: Sat Oct 16, 2004 7:03 am Subject: No oil |
| I found the oil level and coolant level is below the "ok" level and I was wondering if Porsche has a safety switch or something that wont let the car spark if the level is too low? Just a thought. Hit ... | |
| Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
Forum: 931 Discussion Posted: Tue Oct 12, 2004 2:07 pm Subject: 1980 931 ingition troubles |
| I figured out what carparts.com was asking for. The numbers are what distiguish which distributor i have. I was gonna order some Standard Ignition parts. Anyways i orderd a Bosch coil, coil pickup, ig ... | |
| Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
Forum: 931 Discussion Posted: Tue Oct 12, 2004 8:41 am Subject: Which is which? |
| I was curious what the difference is between 0237003013 and 0237003018? I was looking up parts on www.carparts.com and was looking up reluctors and pickups and it asks for which ignition type i have. ... | |
| Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
Forum: 931 Discussion Posted: Mon Oct 11, 2004 3:58 am Subject: 1980 931 ingition troubles |
| how hard is it to install a msd ignition? which is better a 6a or 6al? And where is a good place to get a good deal on a msd ingition? Is it possible to run the fuel pump of the ignition so when i tur ... | |
| Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
Forum: 931 Discussion Posted: Fri Oct 08, 2004 6:46 am Subject: 1980 931 ingition troubles |
| So I did some tinkering yesterday. I tested the module for power. It is getting power. I tested the wires and coil wire. Plug wires have 10-11 ohms resistance Coil wire has 17 ohms. I tested to see th ... | |
| Topic: 1980 931 ingition troubles |
|
| Clay Replies: 14 Views: 14701 |
Forum: 931 Discussion Posted: Wed Oct 06, 2004 1:35 am Subject: 1980 931 ingition troubles |
| To see what has been going on go to the "1980 Porsche 924 for sale (feeler)"
To continue: I checked the voltage from the positive side of the coil to the ground side using a volt meter with the ign ... |
|
All times are GMT + 10 Hours |
Powered by phpBB © 2001, 2005 phpBB Group