 |
924Board.org Discussion Forum of 924.org
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
924 FAQ (Technical)| Search found 125 matches |
| Author | Message |
|---|---|
 Topic: Where does it go? |
|
| BillA Replies: 1 Views: 3321 |
 Forum: General Discussions Posted: Thu May 18, 2023 2:47 am Subject: Where does it go? |
| Does anyone have any ides where this connects to on the backside of the fuse block in the G section 1-9. it is the white wire I've seen posts related to this wire (white) and there doesn't seem to be ... | |
| Topic: 81 fuse block image |
|
| BillA Replies: 1 Views: 4007 |
Forum: 931 Tech. Posted: Thu Apr 27, 2023 10:24 am Subject: 81 fuse block image |
| Does anyone have a pic of the back side of the fuse block, specifically an image of G and H looking for something reasonably close. Look throughout the board have several different typed variations. ... | |
| Topic: Circuit board |
|
| BillA Replies: 2 Views: 13471 |
Forum: 931 Tech. Posted: Mon Aug 03, 2020 4:03 am Subject: Circuit board |
| Looking a little help, can anyone have a layout of this portion of the circuit
board (backside circled) as to what each wire goes, the schematics I have only have about half mentioned. If anyone is ... |
|
| Topic: Got Fuel, no crank, absolutely nothing! |
|
| BillA Replies: 1 Views: 6585 |
Forum: 931 Discussion Posted: Sat May 30, 2020 10:38 pm Subject: Got Fuel, no crank, absolutely nothing! |
| Need some help! Did some major work on the interior over the past winter/year. Repaired the dash, seats reupholstered, new shift boot, new turn signal switch and ignition starter switch (key would tur ... | |
| Topic: Cooked wiring |
|
| BillA Replies: 0 Views: 4686 |
Forum: General Discussions Posted: Sun Jun 09, 2019 11:57 am Subject: Cooked wiring |
| Replaced the turn signal (smart switch) today, after I started it, I had smoke coming from the steering column. I shut it off immediately, pulled the steering wheel off and turn signal/wiper assmebly. ... | |
| Topic: RPM Gauges |
|
| BillA Replies: 2 Views: 5385 |
Forum: General Discussions Posted: Mon Aug 20, 2018 8:24 am Subject: RPM Gauges |
| Is it possible to run an 1983 944 RPM gauge (yellow) on an 81? Connectors are different, however can it be wired to run? Also, where can I find the black body trim or would it be better to just remove ... | |
| Topic: RPM Gauges |
|
| BillA Replies: 0 Views: 14771 |
Forum: 931 Tech. Posted: Mon Aug 20, 2018 7:40 am Subject: RPM Gauges |
| Is it possible to run an 1983 944 RPM gauge (yellow) on an 81? Connectors are different, however can it be wired to run? Also, where can I find the black body trim or would it be better to just remov ... | |
| Topic: What's the secret |
|
| BillA Replies: 1 Views: 4096 |
Forum: General Discussions Posted: Mon Feb 12, 2018 5:21 am Subject: What's the secret |
| Pull the gear shifter with the intent of putting new leather on it. Got everything out, whats the secret to pulling the new leather over the knob. I don't want to pull it to hard for fear of tearing i ... | |
| Topic: Car is now "bucking" on boost |
|
| BillA Replies: 14 Views: 19703 |
Forum: 931 Tech. Posted: Sun Jun 18, 2017 8:59 pm Subject: Finally |
| Ideola,
I think my over boost bucking issue is the result of not having installed lower charge tube bracket. I've gone through the entire twice and couldn't find anything wrong. Racking my brains ov ... |
|
| Topic: Expansion Tank |
|
| BillA Replies: 4 Views: 9934 |
Forum: 931 Tech. Posted: Sun Mar 20, 2016 11:59 pm Subject: Expansion Tank |
| Does anyone know if a 944 coolant expansion tank will fit in the 931. I have one on hand and doesn't appear that it will fit due to the headlight motor.
Thanks. Bill |
|
| Topic: Gears engaged but nothing |
|
| BillA Replies: 3 Views: 2714 |
Forum: General Discussions Posted: Mon Feb 15, 2016 3:53 am Subject: Gears engaged but nothing |
| Rasta,
Finally got around to checking the CV's and you were right, failed right rear CV!!!! Thanks again Bill |
|
| Topic: Gears engaged but nothing |
|
| BillA Replies: 3 Views: 2714 |
Forum: General Discussions Posted: Fri Feb 05, 2016 12:09 pm Subject: Gears engaged but nothing |
| Rasta,
Thanks I'll check it out. |
|
| Topic: Gears engaged but nothing |
|
| BillA Replies: 3 Views: 2714 |
Forum: General Discussions Posted: Fri Feb 05, 2016 12:01 pm Subject: Gears engaged but nothing |
| So, I was driving about 15-20 mph went to shift and felt like something let loose, the vehicle stopped accelerating. I came to a complete stop on the off ramp and I tried all of the gears, but no use. ... | |
| Topic: Blew it's cookies |
|
| BillA Replies: 4 Views: 7560 |
Forum: 931 Tech. Posted: Sat Dec 12, 2015 11:20 pm Subject: Blew it's cookies |
| Dan, I installed a copper head gasket and there isn't any signs of water in the oil? | |
| Topic: Blew it's cookies |
|
| BillA Replies: 4 Views: 7560 |
Forum: 931 Tech. Posted: Sat Dec 12, 2015 8:13 pm Subject: Blew it's cookies |
| One my way to work yesterday, I happen to look out the rear view mirror and saw what looked like heavy fog rolling in? However I realized very quickly it was the car! Luckily I was just pulling in t ... | |
All times are GMT + 10 Hours |
Powered by phpBB © 2001, 2005 phpBB Group